|
| |
|
|
Product
Series |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
|
|
|
|
 |
Installation
Procedure and Criteria to Restrain Stone Panel to Hollow and Solid Back-Up
The Panel-Tie 6100 Series anchors provide an excellent method of restraining
(tension only) a solid façade <3” thick to various solid
or hollow backups. A 1/2” veneer hole and 3/8” back-up hole
can be easily achieved in one step using a dual diameter bit, followed by
a 1 1/4” diameter countersink hole in the veneer. Anchor placement
is only restricted by edge and spacing distance. Anchors are installed with
a setting tool, via torque 50-100 in-lb in the back-up. Veneer connections
should be tightened 1/4 – 1/2 turn past hand tight. Custom lengths
available upon request. Counter-boring drill bits available upon request. |
|
|
 |
|
|
 |
Installation
Procedure and Criteria to Restrain Stone Panel to Hollow Back-Up
The Panel-Tie 6100-TGL Series anchors provide an excellent method of restraining
(tension only) a solid façade <3” thick to hollow backups.
A 1/2” veneer hole and 7/16” back-up hole can be easily achieved
by using quality masonry and steel drill bits, followed by a 1 1/4”
diameter countersink hole in the veneer. Anchor placement is only restricted
by edge and spacing distance. Anchors are installed with a setting tool,
via torque 50-100 in-lb in the back-up. Veneer connections should be tightened
1/4- 1/2 turns past hand tight. Custom lengths available upon request. Counter-boring
drill bits available upon request. |
|
|
 |
|
|
 |
Installation
Procedure and Criteria to Restrain Stone Panel to Steel Back-Up
The Panel-Tie 6100-S-TGL Series anchors provide an excellent method of re-anchoring
(tension and compression) a solid façade <3” thick to various
solid backups. Anchor is installed by drilling an appropriate hole through
veneer, and in back-up followed by a 1 1/4” diameter countersink hole
in the veneer. Anchor placement is only restricted by edge and spacing distance.
Anchors are installed with a setting tool, via torque 50-100 in-lb in the
back-up. Veneer connections should be tightened 1/4- 1/2 turns past hand
tight. Custom lengths available upon request. Counter-boring drill bits
available upon request. |
|
|
|
|
|
